GENERAL
DESCRIPTION: Cool S-2000 is a general purpose
synthetic coolant based on polyalkylene glycol chemistry.
It is designed for use on ferrous and nonferrous metals.
Cool S2000 has a high degree of lubricity as well
as corrosion protection and cooling properties. Cool
S-2000 is non-staining and rejects tramp oil. Cool
S-2000 contains no nitrites, boron, sulfur or chlorine.
PHYSICAL PROPERTIES:
Appearance: Blue
Odor: Characteristic
pH @ 1:20: 8.6
Cast Iron Chip Corrosion Test 1:20: Pass
Density: 8.7 lb./gal
Lubricity @ 1:20: 4500/45
(#8 pin, 1137 AISI steel blocks)
Foam: Low, fast breaking
USE PROCEDURE: Cool S-2000 may be diluted from
1:10 to 1:30 depending upon the type and severity
of the application. Cool S-2000 should be added to
water or premixed with a direct action proportioning
pump such as those manufactured by Dosatron.
SAFETY DATA: Cool S-2000 is slightly alkaline
and may cause irritation to skin and eyes. If skin
or eye contact occurs, flush affected area with water
for 15 minutes. If irritation occurs or persists,
seek medical attention. If irritation occurs due to
inhalation of mists, move to fresh air. If irritation
persists, seek medical attention immediately. If ingested,
give two or three glasses of water to dilute and seek
medical attention immediately.
The information contained in the bulletin is, to the best of our knowledge, true and accurate. All recommendations or suggestions are made without guarantee, since the conditions of use are beyond our control. Michigan Industrial Coating, Inc. disclaims any liability in connection with the use of the data or suggestions.
