Michigan Industrial Coating, Inc.
Technical Data
 MIC-1040
Synthetic Solvent

GENERAL DESCRIPTION: MIC-1040 is a heavy duty degreaser and will attack the toughest soils and yet is easy on the hands. It was developed for the parts washer industry as a replacement for the toxic solvent Mineral Spirits. MIC-1040 is a water base biodegradable degreaser that allows oils taken up in the cleaning process to separate from the solution for skimming and thereby lengthens the life of the cleaner. The spent solution maybe disposed of into the city sewer system. MIC-1040 maybe used in most cleaning systems, but was designed for a heated parts washer with an oil skimmer for optimum cleaning. It works best on greases if heated to 100°F to 115°F and rivals mineral spirits in its cleaning ability if so used. The following is a comparison of MIC-1040 and Mineral Spirits as to their toxicity:

FLASH POINT:
Mineral Spirits: 105°F. This is 35°F below the flammable classification for solvents. MIC-1040: None. Non-flammable.

THRESHOLD LIMIT VALUE (TLV):
Mineral Spirits: 100 ppm vapor in air. Trichlorethylene: 100 ppm vapor in air. MIC-1040: None

EVAPORATION RATE:
Mineral Spirits: 0.15 (butyl acetate = 1)
MIC-1040: As water. Product is lost when mineral spirits evaporates, whereas only water is lost on evaporation of MIC-1040.

UNUSUAL FIRE OR EXPLOSION HAZARDS:
Mineral Spirits: Vapor accumulation may flash and/or explode if ignited. Use with adequate ventilation. Keep away from heat, sparks, and open flame.
LP-1040: None. Non-flammable.

WASTE DISPOSAL METHOD AND SPILLS:
Mineral Spirits: May not be sewered. Must be contained and hauled away.
MIC-1040: Skim oil and dump in drain. Mop up spills.

HOW TO USE: Concentration: 10% to 20%. Performs most effectively in warmed solution. MIC1040 is designed for use in a parts washer, but may be used in dip tank or spray application. It is safe on all metals.

SAFETY DATA: MIC-1040 does contain alkaline materials. When handling the concentrate, do not get in eyes. Wearing gloves and eye shield is always good practice when handling any chemical. Some persons may be sensitive to the pH of the cleaning solution (pH at use dilution = 10.5 to 11.0). If so, gloves should be worn to avoid this. Read the Material Safety Data sheet on this product before using.

The information contained in the bulletin is, to the best of our knowledge, true and accurate. All recommendations or suggestions are made without guarantee, since the conditions of use are beyond our control. Michigan Industrial Coating, Inc. disclaims any liability in connection with the use of the data or suggestions.